The Twincontroller is software controlled with Motion Flow and not mechanical like other controllers. Therefore, it reacts completely different from the usual controllers.
The Twincontroller is controlled in a way, that the fans adjust slowly but lasting to the preset temperature, when the upper temperature limit is exceeded. The advantage of this principle is, that the fans will not run on full load at once and all together, which would cause a loud turbine-like noise. More than that you don't have to adjust again and again, for the optimal speed, because the right speed will remain long-lasting.
You set the speed of the fan according to the optimal humidity by the left knob. For the exhaust air should always be stronger than the inhaust air, you have to make sure, that the fans are plugged to the Twincontroller in the right sockets. The fan for the inhaust runs faster automatically.
In case you have two fans of different sizes, always plug the bigger one to the exhaust air-socket. The right knob then, has to be set on 80 to 100. When your fans are of equal size, this right knob should be on ca. 50. The knob in the middle is to set the upper temperature limit.
In case the inhausted air is already warmer then the upper limit (e.g. in summertimes) you will need an air conditioner.
Adjustable capacity: Max. 7 A
Frequency: 50/60 Hz
Temperature sensor cable = 2 m
ca. 14cm height
ca. 14cm width
ca. 9cm depth
VPE anzeigen: nein
- 11,10 €*
|From 10 run. meter » 8,10 €*|