This ebb/ flow table inlay is especially suitable for the cloning of cuttings and needs a hole of 30 mm Ø. To drill this hole without getting the plastic to burst, you should use a quick-helix drill.
For an extra charge we can drill those holes for you:
For in- and outlet: 4€
For the outlet: 3€
Just leave a short note regarding the wanted bore in the commentary field that pops up at the end of your order.
If no note is left behind, you automatically receive the untreated table inlay.
This hole is crucial, because we need an inflow and an outflow at the flood table. You have to connect the hole with a hose. Through the inflow you flood the table until all plants are watered. The mat of inorganic fibre (garden fleece), that you put underneath the plants before, gets wet as well. And then the water goes back down throug the same hole afterwards.
If some of the roots are without coverage they now take dampness from the mat. Without the mat they would be in danger to dry up quickly, because the level of evaporation is very high in the heat of a growbox.
With this procedure you can irrigate bigger areals more evenly. Each plant recieves the same amount of water.
Unfortunately the flow table inlay has very big dimensions, so the shipping will cost more than the normal charge, since we have to
ship it with a bulk surcharge. Please ask us before ordering this product to avoid any misunderstandings. But these charges are only to
be paid once when you order more than one of this item.
VPE anzeigen: nein
Question on item
- 8,95 €*
- Base price: 0,02 € per 1 ml
- 79,90 €*
- Base price: 7,99 € per 1 l
- 11,90 €*
- Base price: 11,90 € per 1 l
- 34,90 €*
- Base price: 6,98 € per 1 l